How To: Center Pocket

[MyNameIsThien]

This will be a DIY on removing and installing the center pocket. Sorry for the crappy pics. I was using my cell phone, but I hope this will help anyone who will be doing this. I will try to be as thorough.

Tools:

Philips Screwdriver
Flathead Screwdriver

1: Open the "This Is Not An Ashtray" pocket and Power Outlet pocket.



2: Pull up on the shifter assembly trim.



3: Disconnect heated seat plugs by pushing in the little tab in the middle of the plug. (If applicable)





For Automatics. (Skip this step if you have a manual transmission)
4: Use a small flathead screwdriver to pry open the shifter assembly emergency gear selector. Use your key and press down to move your shift knob to a position to where you can remove your shifter assembly trim.




5: Remove the "This Is Not An Ashtray" rubber cover.



6: Unscrew the two bolts located on the outer edges of the two lower pockets.




7: Use a flathead screwdriver and pry open the "This Is Not An Ashtray" tray.



8: Under the tray you will see 2 screws. Proceed to unscrew them.




9: Pull up on the lower pockets.



10: Unplug the power outlet plug.



11: Unscrew the 2 screws that hold the center pocket down.





12: Pull the center pocket out.




Install center pocket in and install in reverse order. Here I replaced my center pocket for the carbon fiber one. The outcome is as follows.

[Mike]

I never knew about the emergency gear selector.... I always just put the key in. Thanks for dropping knowledge on me