What did you do to your Gen7 today?

[Mike]

Some seedy characters... No Modesto for me then.

[timot_one]

If it was professional, there wouldn't have been innocent bystanders.

[thisaznboi88]

If it was professional, there wouldn't have been innocent bystanders.

I ono man seem kinda shady that he knew who the person was that did it. Like if it was a local gang all they would do is spray and pray. Then get caught because they are stupid. But this one was a lone gun men on a "Performance Bike".

here an update

http://www.modbee.com/2010/06/16/121329 ... capes.html

[timot_one]

I was talking about the M6.

[Mike]

Funny story about expensive cars getting hit with stuff. I went to visit my buddy at a local Mercedes dealer today. He is a plumber and they were doing some sprinkler work. One of his former co workers proceeded to drop a drill form about 30 feet onto the hood of a 2010 CL65 AMG.... I gave him a ride to his truck in my Accord after he was fired for crushing the hood of a $208,000 car.

[wtcii]

Haha wow! He got fired for that though? That's crazy. I still laugh when I think of my neighbor backing her SL63 in to her brick mail box and sitting on the ground pounding the road with her fists.

[timot_one]

lolz

[sherker55]

I vaccumed the inside and trunk

[fabulous010]

replaced the rear passenger side caliper and bracket with a new one from honda. cost my $275 installed. not bad. hope that was the culprit to my brake pad sticking to the rotor. so far so good. thanks tim!

[cna]

Order a short ram intake cracked my 2nd cold air intake damm bracket

[thisaznboi88]

damn what intake do you have? AEM?

[cna]

^^ i was using a custom TL cold air intake 3 in piping it was sweet but the whole side of where the bracket was holding it to the car cracked  so time to try something different

[timot_one]

I installed a spacer for my clutch master cylinder yesterday, then adjusted the free play.  I also hit my rear knuckles with some PB blaster and checked to see if any of the nuts and bolts were frozen.  Everything seems to be good, so I need to find the time to do my rear brake swap.

[thisaznboi88]

Tried to replace my rubber flex lines with Stainless steel lines. FML The ABS bolt was stripped before I had a chance to turn it using the special wench. So going to sell it

On the bright side the wench did help me bleed my brake lines very well ^^. Now I need to do the clutch.

[status]

started off well with a wash and super coat of wax, then i changed the tranny fluid wish was a mother fucking bitch for me at least, then to be responsible i took the oil to the dump, and got a nail in my tire there...