Not bad for a DIY if I do say so myself.

I'd like to know more about how you did yours.

Took off the moldings, popped out the clips, welded on small metal pieces I fed from inside the door panels, a little filler to smooth things over, prime and paint.

I wasn't going for absolutely perfect as I have more things planned but for a little bit of time and not much invested, it does the job.

^this

Not bad for a DIY if I do say so myself.

This happened

Yeah! Stab them like they deserved it!

Side moldings officially shaved. Just need to throw down some paint to finish the job. Shaving the rear Honda badge next.

Ripped off my side moldings. Will fill the holes tomorrow.

Removed what was left of my botched plastidip job and gave it a quick wash.

I've always had good luck with the BFG g-Force sports. I didn't care for the Hankook Ventus V12's much. Definitely going to be trying some Toyo R888's or Nitto NT01's next. Once I get a jobby job and some money to put tires on the Volks.

Those are exactly what I threw on. Funny how they seem wider than the old tires I was running. Have a little rubbing in the rear DS quarter but that's because of the 3mm spacers I run. I expected a bit of rubbing since that quarter wasn't pulled as much as the PS so I'll probably even that out rather than remove the spacers.

Throwing on a new set of rubbers as I type this. Wore them old kumho's down to almost nothing. Wasn't too impressed with them even when they had good tread. No wonder they were discontinued. The new bfg's I'm throwing on look real promising.

Wow! Congrats bro! Forget about sleep anytime soon.

I just recently did an upgrade to cr-v calipers with tsx rotors. Basically just oem replacement from advance auto for the pads and rotors. Too soon to tell as far as longevity but based on past experience with the stock accord brakes, I'm already past the point on the new setup where the stock setup would start to give vibrations.

Taking the browns to the Superbowl.

Functional setups FTMFGDW

Hahahahaha

Well played Jer