I love stance but going performance with my 05 v6 6speed. Engine is all stock but I want to finding up my suspension first.  My current set up
235/45 continental DW on 17x8.5 rpf1s. F&F type 2 with rear camber arms.

Installed my 7.5 tails on my 7.

What happened to the pics of the roll job? I can sort of see what happened in the back but not completely.

Haha I keep forgetting. It's just a half ass roll because of the undercoating behind it

Update on how it sits.  Still some rubbing from the rear but not as much as there was yesterday.  I added a few more negative degrees of camber

Curious about the fenders as well.  Liking those RPF1s BTW

Thank you

Do you have a picture of said fender roll job? I'd like to see what happened in there.

Ill hey pics at some point. The upper part of the tire is rubbing on my roll. The lady who owned this before me had under coating sprayed on so there's a lot of crap on the inner fender that I need to scrape out in order to roll it farther(didn't know under coating was there until day of rolling)

Hang on a second. It may not be your fenders. Check your bumper tabs before you start cutting your inner fender up. I wouldn't be surprised if you have small grooves in your tires just below where your tread stops.

I'm pretty sure it's the fender. I taped up the rear fenders and there were tire marks on the tape where it hit. I'm gonna cut and than I may adjust more rear camber if I need too

Needs moar lows!

I lowered the rear 1/2 and the front 1/4 today and adjusted my rear camber but I still rub.  I'm just going to cut out my inner fender that was rolled crappy.

Rpf1s in. 235/45 tire. Need a little more rear camber